Sleep Sensor

Reporting normally

Exit Demo
Detections last night — 22:45 to 07:30
Longest motion-free —  
First and last motion —  
Typical longest interval — Average across all nights

Detections

Most recent first

When
09/23/2604:09:20 AM
09/22/2611:50:57 PM
09/22/2611:37:22 PM
09/22/2611:31:08 PM
09/22/2607:32:49 AM
09/22/2606:47:24 AM
09/22/2602:32:52 AM
09/22/2601:51:04 AM
09/22/2612:55:14 AM
09/22/2612:36:53 AM
09/22/2612:31:43 AM
09/22/2612:09:53 AM
09/21/2610:56:22 PM
09/21/2605:47:26 AM
09/21/2601:53:02 AM
09/21/2601:00:50 AM
09/21/2612:08:39 AM
09/20/2611:44:34 PM
09/20/2611:40:21 PM
09/20/2611:28:47 PM
09/20/2611:10:42 PM
09/20/2607:43:16 AM
09/20/2607:32:33 AM
09/20/2607:18:05 AM
09/20/2603:37:31 AM
09/20/2612:23:42 AM
09/19/2611:32:25 PM
09/19/2607:09:31 AM
09/19/2604:27:20 AM
09/19/2602:12:25 AM
09/19/2612:54:07 AM
09/18/2611:44:23 PM
09/18/2611:15:12 PM
09/18/2607:07:25 AM
09/18/2602:28:36 AM
09/18/2601:29:36 AM
09/18/2612:14:40 AM
09/17/2611:33:11 PM

Motion by hour

 

Cumulative detections by hour

 

Longest nightly motion-free interval

Nights with no detections are excluded

Min/Max Range — Sleep Sensor

feet
Allowed 1–26 ft, in half-foot steps; minimum must be below maximum.
feet
The sensor picks up saved changes automatically — allow a minute or two for them to take effect.

Detection Cooldown — Sleep Sensor

minutes seconds
Allowed 30 seconds to 30 minutes.
The sensor picks up saved changes automatically — allow a minute or two for them to take effect.

Radar Sensitivity — Sleep Sensor

Most sensitiveLeast sensitive
Position 5 is the profile measured on the camera boards in service; above 5 the slider moves in tenths. Lower catches smaller movement and more of the room’s own noise; higher only reports what is unmistakable.

Detection Time — Sleep Sensor

seconds
Allowed 0.1 to 5.0 seconds, in tenths. Nominal 1.3 seconds.
A shorter time catches smaller movements and risks counting a passing one; a longer time only logs movement that stays.

Test Mode — Sleep Sensor

For checking a change now instead of waiting for tonight. Detections outside the monitoring period are stored, and appear in the list rather than on the nightly charts.
This stays on until you turn it off, including after the sensor restarts. Leave it on and the sensor keeps recording all day.

Monitoring Period — Sleep Sensor

:
:
Times are in the sensor's own local time zone. Changes take a minute or two to take effect.

Rename Sensor — Sleep Sensor

Display name only — the device key Sleep Sensor does not change.

If this is a replacement unit, the existing detection history belongs to the old sensor. Delete that history and start fresh?

Deleting is permanent and also removes events you previously deleted by hand. The rename is saved either way.